Boonton 4500B Peak Power Meter Uživatelský manuál stáhnout pdf (Strana 336)

Boonton 4500B RF Peak Power Analyzer

Maintenance

7-4

7.7 Performance Verification

The verification procedure demonstrates that the Model 4500B is performing according to the

specifications published in section 1.6 Specifications. This procedure should be performed when

the instrument is first put into service and after making repairs or adjustments. Performance

verification should be repeated at least once every twelve months.

Checklist The verification procedure is outlined in Table 7-2, Verification Checklist. Each time you verify



the copy to provide a record of instrument history. Attach additional sheets as instructed in the

verification procedures.

Fuse Rating The 2 fuses should be size 3AG, 250 volt, 1.6 amp, Type-T.

Serial Number 

memory. View the stored serial number by selecting Util > Inst Status > REPORT. The stored

serial number should match the number on the rear panel. If the numbers do not match, contact

Boonton Electronics Service. Record the instrument serial number on the Checklist.

Control Software Ver The control software version number appears on the screen at power-up and may be displayed by

selecting Util > Inst Status > REPORT. Record the control software version number on the

Checklist.

Time and Date The time and date are factory set and maintained internally by a battery-backed real time clock.

The time is set initially to U.S. Eastern time and may be viewed and adjusted by selecting Util >

Clock. The time and date are not updated while they are being displayed. Record the time and date

on the Checklist.

Sensor Serial Number

The s

View the sensor serial number (as well as the sensor model number and frequency range) by

selecting Spcl > Sensor Data > CH # Sensor > REPORT (# designates the numerals 1 or 2). The

stored sensor serial number should match the number printed on the sensor. If the numbers do not

match, contact Boonton Electronics Service. Record the stored serial number on the Checklist.

1 2 ... 331 332 333 334 335 336 337 338 339 340 341 ... 371 372

Žádné komentáře

Boonton 4500B Peak Power Meter Uživatelský manuál Strana 336